本文由金属剪切机、废钢打包机厂家江阴市鸣澄液压机械有限公司整理提供，更多资讯请访问：www.jsmcyy.com
打包机的调整方法:
1. 带子宽度及接合口调整当带子宽度不匀或更换另一种宽度的带子时，必须调整左、右插带槽太窄时，插带困难;太宽时，废钢打包机捆包后带子接合处会搭接不齐。一般插带槽宽度应比带子宽度宽0.5-1毫米左右。
1. The belt width and joint mouth adjustment when band width is not well or replace another kind of the width of the belt, must adjust left and right in grooved is too narrow, inserted with difficulty; Too wide, baling press bale strap joint will lap. Generally inserted slotted width than band width should be about 0.5 1 mm wide.
2, baling press permed hair permed hair temperature adjustment of high and low temperature to influence the quality of belt joint. To make polypropylene strapping tape joint cement, knob generally in 3-5 file location. Check for permed hair permed hair temperature is appropriate, surface adhesion. If permed hair surface with white marks, the temperature is high; If permed hair surface is wet, the temperature is insufficient.
3. Press bale strapping elastic adjustment of open stage face plate, with the hand will pick the mother A hex screws loosen set above, clockwise direction for tight, otherwise it loose. After binding force is moderate, will be hex socket set screw.
4. Send belt length adjustment to send out the length of the tape is decided by sending belt length controller front panel. If the tape is too short, the easy to hand tied up, at this point, the packer usable hand to seize the lead along the direction to send belt pull the cord. But need to adjust the belt length, again to ensure the normal of the strapping machine. Packer if the belt is too long, it is not easy alignment position, press the lace and panasonic to cause belt around together to prohibit or broken.
 |
|||||
|
|
|||||
 |
|||||