本文由金属剪切机、废钢打包机厂家江阴市鸣澄液压机械有限公司整理提供，更多资讯请访问：www.jsmcyy.com 

金属剪切机的保养注意事项：
（1）每星期一次将机器料箱内的废屑或脏物清除。
（2）每月一次将滑板与中刀及前顶刀清洁保养润滑做一次。
（3）每三个月一次除将以上两个保养做过后,再将所有轴承处添加润滑油。
（4）每两年一次补充减速机轮箱内机油。
（5）须注意几个零件不可加油： 一送退带滚轮，二所有皮带，三打滑片及周围。
（6）每次加油时，应当适量，不可过量添加，以免微开关因浸油而产生故障。

 

Metal baling press maintenance notice:
(1) once a week to clear the scraps or dirt that material in the machine.
(2) once a month to skateboard with knife and former top knife in the cleaning and maintenance lubrication.
(3) once every three months in addition to the above two maintenance is done, then add all in bearing lubricating oil.
(4) every two years on a supplement to slow down the oil in the cabinet.
(5) must pay attention to several parts do not come on: a send back roller, two all belts, three sliding plate and the surrounding.
Every time (6) come on, should be moderate, not too much to add, in order to avoid the micro switch failure due to oiled.