本文由金属剪切机、废钢打包机厂家江阴市鸣澄液压机械有限公司整理提供，更多资讯请访问：www.jsmcyy.com

 

　　 打包机工作流程：带子送到位→收到捆扎信号→制动器放开，主电机启动（1）→右顶刀上升，顶住右带于滑板处（2）→"T"型导板后退（3）→接近开关感应到退带探头（4）→主电机停转，制动器吸合（5）→打包机退带电机转动，退带0.35秒（6）→带子收紧捆在物体上（7）→主电机二次启动，制动器吸合（8）→大摆杆二次拉带，收紧带子（9）→左顶体上升，压紧下层带子（10）→加热片伸进两带子中间（11）→中顶刀上升，切断带子（12）→中顶刀下降（13）→中顶刀再次上升，使两带子牢固粘合（14）→中顶刀下降，左右顶刀同时下降（15）→加热片复位（16）→滑板后退（17）→"T"型导板复位（18）→接近开关感应到送带探头（19）→送带电机启动，带动带子送带（20）→大摆杆复位（21）→带子到位，带头顶到"T"型导板上（22）→接近开关感应到双探头（23）→主电机停转，刹车吸合（24）→打包机完成一个工作循环。

Packer working process: send tape in place to receive strapping signal, brake release, main motor startup (1) - > right knife rising, to resist the right belt in skateboard (2) - > type "T" guide back (3) - > proximity switch induction to bring back the probe (4) and main motor stalling, brake and (5) - > packing machine with motor rotation, back out with 0.35 seconds (6) - belt tightening bundle on the object (7) and main motor second start, brake and posed rod (8) and a secondary drawstring, tighten belt (9) - > left acrosome rise, the lower clamping belt (10) - heating into two straps (11) - in the middle top knife, cut the ribbon (12) to the top knife down (13), the top knife to rise again, make the two straps and strong adhesion (14) of the top knife down, left and right top knife fell at the same time (15) and the heating piece reset (16) to slide backward (17), "T" type guide reset (18), close to switch to send with the probe (19) - > send belt motor start, drive belt to send belt (20) - big swinging rod reset (21) - belt in place, leading the top to the "T" type plate (22), close to switch to double probe (23) and main motor stalling, brake and (24) to press to complete a working cycle.